Black & Decker FSNS100 Manuál s instrukcemi stáhnout pdf (Strana 8)

USING THE TOOL

Complete all steps of PREPARING THE TOOL before using the tool.

This tool is shipped from the factory with a “single sequential actuation” trigger. To

fire, grip the tool firmly to maintain control, position nose of tool onto work

surface, push the tool firmly against work surface to depress safety (S) Fig. 28,

and squeeze trigger to fire a fastener. Allow tool to recoil away from work surface as

fastener is driven. This “single sequential actuation” method provides the most

accurate fastener placement.

Disconnect tool from air supply before performing

maintenance, clearing a jammed fastener, leaving work area, moving tool to

another location, or handing the tool to another person.

Clean and inspect tool daily. Carefully check for proper operation of trigger and

safety mechanism. Do Not use the tool unless both the trigger and the safety

mechanism are functional, or if the tool is leaking air or needs any other repair.

Fig. 26

Fig. 27

OPERATING INSTRUCTIONS

Fig. 28

635549-00,FS2NC 7/13/05 10:10 AM Page 8

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 35 36

Žádné komentáře

Black & Decker FSNS100 Manuál s instrukcemi Strana 8