Black & Decker FSM1630S Servisní příručka Strana 7

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 56
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 6
7
ENGLISH
(Original instructions)
Technical data
FSM1630S
(Type 1)
Voltage V
ac
230
Power W
1600
Tank capacity ml
500
Weight kg 3.4
Troubleshooting
If your appliance seems not to operate properly, follow the
instructions below. If this does not solve the problem, please
contact your local Black & Decker repair agent.
Problem Step Possible solutions
The steam mop is
not turning on.
1
Check the unit is plugged in at the wall
socket.
2
Check the unit is switched on using the on/
off switch (1).
3 Check the fuse in the plug.
The digital controls
do not light up.
4
Check that the handle (4) of the steam mop
is pushed rmly into the steam mop body
(13). Check that the arrow on the handle is
ush with the top of the steam mop body
(13).
5 Check steps 1, then 2, then 3.
The steam mop is
not producing
steam.
6
The steam mop will only produce steam
once the handle is pulled back from the
upright position.
7
Check that the water tank (3) is full and
correctly tted.
NOTE: When rst lled or after running dry it
can take up to 45 seconds for steam to be
produced.
8
Check that the Steam head (5) is rmly
docked into the steam mop body (13).
9 Check steps 1, then 2, then 3.
The digital controls
go out during use.
10 Check steps 4, then 5, then 1, then 2, then 3
The steam mop
stops producing
steam during use.
11 Check steps 6, then 7, then 8, then 4, then 3.
Problem Step Possible solutions
The steam mop is
producing too
much steam during
use.
12
The steam mop has 3 settings. Press the
autoselect button (2) to reduce the amount of
steam being produced.
13
Check that the steam burst button (21) has
not been pressed.
The steam mop is
producing too little
steam during use.
14
The steam mop has 3 settings. Press the
autoselect button (2) to increase the amount
of steam being produced.
15
Press the steam burst button (21) to
temporarily increase the amount of steam.
Steam is escaping
from unexpected
areas of the unit.
16
Refer to the assembly chapter of the manual
for correct tting instructions of all parts and
accessories.
Where can I get
further information
/ accessories for
my steam mop.
17 www.blackanddecker.co.uk/steammop
www.blackanddecker.ie/steammop
Zobrazit stránku 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 55 56

Komentáře k této Příručce

Žádné komentáře